Not quite a sizzle reel for the #handheld, but I’m going to start posting videos of games running on this thing. Again not sure how playable games will be over the course of a whole game start to finish but I’ve played each of these for about an hour and they’ve held up.
Tag Archives: Diy
So I got DM’ed by a troll who claimed that since the #nintendoswitch can play #Skyrim I was really just wasting my time. Now he might be right (from a pure time perspective) but I’ve had fun making this…having said that…here’s some Skyrim since apparently for your #handheld to be “worth it” it’s got to play Skyrim. Started a new game, not sure how smooth it might be FPS wise later on but the intro wasn’t too bad. Note, video is sped up 200%. Sorry for the blue cast on everything, the lighting in my apt isn’t good for video.
I figured a #Zelda shot was long overdue…(even though wii emulation isn’t a feat)
TLDR; got done with version 2 of my portable #steammachine based on #florianrenner ‘s awesome #gameboy1up concept… now onto version 2.5!
-Managed to shave off a 1/4″ in the depth and about 1/8″ in the length and width. Unit now measures: 7 3/4″ (197mm) x4 3/16″ (106mm) x1 1/32″ (26mm)
-Installed battery. Version 1’s battery never fit right.
-Xinput instead of Dinput using Zachery Littell’s ( @msf_reaper ) awesome library for the TeensyLC.
-Switch between mouse mode and gamepad mode using a key combination. Similar to the steam controller’s reptile mode.
-Replaced analog volume control with digital
-Buttons locations and sizes tweaked
-Used UV glue to bond the LCD plexi to the screen. Didn’t protect it enough so some of the glue got into the backlight
-Clean up all mistakes on the case
-Add battery management logic, low power notification, etc.
-Continue to tweak button ergonomics
-Create a simplified version to house a raspberry pi and model
-Speakers, I usually use headphones with handhelds so this has been a bit of a lower priority
-Paint the inside of the case a dark color and mask LEDs so they don’t shine through.
Screen size is driving the overall size of the case. It’s pretty large as is but basing it on 5″ doesn’t actually give you all that much volume to work with. I’ve been thinking of making a 7″ version of this which would allow me to use beefier hardware. I’ve got a M7 board that’s dying to get used. Still based around an @intel m3 processor.
Not pretty but it works; added an on/off switch, a play/pause button, low power led and an on/off led. Will eventually cover the exposed bits with vinyl tape. Also had to add an antenna salvaged from an old router since the range on the #bluetooth dongle was pretty terrible. #wireless@gradolabs #sr60 #headphones
While waiting for paint to dry decided to spend an hour and make an old pair of #Grado#headphones #wireless
I know, I know, I should probably just give up on this now that the #nintendonx has been announced…but meh, obsession is as obsession does…got finished with revisions based on the V1 and have sent out for prints. Managed to cut 1/4″ from the overall thickness which I’m very excited about. For those of you that have asked about board specs, I still haven’t settled on a final board to put in there. Still benchmarking various #coreM3 boards.